Baseline
What the customer was running
- Five-shoe table running at 1085 RPM
- Feed of 550 TPH and above
- Feed size of 2.5" minus (frack sand)
- 18,000 tons per set of shoes
Production tonnage increased by 28% using improved Si-Tec® technology
- Location
- USA
- Feed material
- 2.5" minus frack sand
- Equipment
- Terex Canica 2350 VSI crusher
Parts
- 0050113HS Si-Tec® ceramic shoe
Photography — Surface
Si-Tec® ceramic shoes out of a Canica 2350 after a full set life in frack sand, wear faces up in a row so the wear is comparable across the set.
Measured on site
Throughput per set of shoes increased 28%, from a baseline of 18,000 tons per set.
Terex Canica 2350 VSI crusher — one machine, one feed material
The record
Read the baseline first.
The improvement only means something against what the machine was doing before it. Published 23 January 2020.
Objective
What the change was meant to do
- Increase tons per hour per set of shoes
- Extend wear life of castings
Results
What was measured
- Throughput per set of shoes increased 28% over the 18,000-ton baseline
Value delivered
What it was worth to the operation
- Fewer change-outs results in increased machine up time and improved safety
Read this too
What these numbers are not.
A wear part that lasts twice as long in Tennessee sandstone can do nothing of the kind in Idaho RAP, because the rock, the tonnage, and the geometry are different. Nothing here is a warranty and nothing here is a specification. What SI will do is measure your part in your circuit and put the numbers against the ones you have now.
How Si-Tec® is specifiedSend us what your part does now.
Service life in hours or tons, the feed material, and photographs of where the wear actually is. That is enough to say whether Si-Tec® changes anything in your circuit.
Technical review within 48 hours